Delay of Overseas Postal Services & Postage Adjustment
Hello Valued Customer, Due to the worldwide epidemic our long time mail partner: Hong Kong Post's services has been affected greatly. Rest assured, we have sourced several other courier methods, and hope to send all orders to all our customers around the world. Even with the new courier methods, shipping times will have some delays, hope you will understand that during these difficult times due to reduced flights no courier can function as usual. Sorry for any inconvenience caused.
0 item(s) - USD 0.00

RPM Rear Bumper Mount BLACK for Traxxas 2WD Slash Rustler Stampede Bandit

RPM Rear Bumper Mount BLACK for Traxxas 2WD Slash Rustler Stampede Bandit #80902

Description:

This is a rear bumper mount from RPM, intended for use with the Traxxas Slash, Stampede, Rustler and Bandit 1/10 scale electric vehicles. After hearing numerous requests to look into the rear bumper mount on the Traxxas Slash, RPM has found several issues that could use their special touch. Those same problems were encountered on e-Rustler, e-Stampede & Bandit vehicles using the stock wheelie bar mount. The problem – the stock mount uses only a single screw on the gear cover side to hold the mount in place. That causes a hinge effect under rear impacts causing the slotted area holding on to the rear skid plate to pop off after an impact, leaving the stock bumper/wheelie bar mount hanging under the chassis. The RPM solution…An all-new bumper mounting system that eliminates all of the problems encountered with the stock version.

The RPM rear bumper/wheelie bar mount has two mounting holes on the gear cover side and three on the motor side – that’s two additional mounting points to eliminate that annoying hinge effect mentioned above. The additional mounting screws help disperse impact energy into the transmission case over more surface area, reducing the possibility of damaging the case significantly! The new RPM mount design means no more slotted parts hanging below the rear skid plate – ever! The RPM mount tucks up quite nicely behind the skid plate for better rear end ground clearance.

  • Material: Nylon
  • Color: Black
  • 3x10mm Screw (1pc)
  • 3x12mm Screws (4pcs)
  • 3x16mm Screw (1pc)
  • 3x25mm Screws (3pcs)
  • 3mm Locknut (1pc)
  • RPM sticker (1pc)
  • Instruction
  • ** Please click here for full range of Hop Ups for Traxxas Slash **

    ** Please click here for full range of Hop Ups for Traxxas Rustler Brushed **

    ** Please click here for full range of Hop Ups for Traxxas Rustler Brushless **

    ** Please click here for full range of Hop Ups for Traxxas Stampede Brushed **

    ** Please click here for full range of Hop Ups for Traxxas Stampede Brushless **

    Feature:

  • For: Traxxas Slash, E-Rustler, E-Stampede, and Bandit
  • Include:

  • Mount for a Rear Bumper or Wheelie Bar (1pc)
  • Write a review

    Please login or register to review

    Customers that bought this also purchased...