JConcepts A1R A1 Racer Clear Body For 1/10 RC Touring Car #0356
This is the 190mm wide JConcepts A1R "A1 Racer" 1/10 Scale Touring Car Body in Clear Lexan material. First, the front-end was considerably laid-back, shortening the nose allowing the force to be placed over the leading-edge of the front tires. A-pillar rails extend over the hood for some air deflection straight over the nose. The front windshield appears sunk, however its widely connected to the aggressive roofline giving the A1R is distinctive shape. Behind the front wheel well and in front of the rear wheel well a definitive edge strengthens the openings and also provides better race posture. A hard edge runs the bottom of the rocker-panel providing more grit to the design while also providing extra front to rear rigidity.
Moving to the rear section of the body, the trunk area was reduced giving the body a much shorter overhang. The rear overhang is important, a critical part of the body which controls down-force and provides the placement for the rear wing. To complete the look and finish, the bubbled roof profile and minimally structured greenhouse area allows the body to whisk through high-speed sections.
Included in each body set, a JConcepts A1R decal sheet and paint mask for all windows. The rear wing option includes two styles, first a standard lip design and a gurney option for the ultimate rear down-force tuning. To attach the rear wing, 3mm mounting hardware and plastic nuts are included to complete the light-weight assembly. As always, each body set is backed with JConcepts customer support and racing heritage.
The A1R body is built for all 190mm width touring car vehicles and was designed to meet all the ROAR “global body spec” rules. Standard thickness is most comparable to all sturdy racing bodies on the market. Light-weight is a thinner gauge material, most often used on the world racing scene for the most experienced or weight-conscious racers. Wheel well openings are pre-marked on the clear body (253.5mm), however, depending on the length of the vehicle, these may be altered slightly by the user. The rear wings are 180mm wide each with one featuring a slight gurney for added rear grip.
- For: 1/10 RC Touring Car
- Clear Body
- Material: Lexan
- Clear protective film to prevent overspray: Yes
- Pre-drilled mounting holes: No
- JConcepts, A1R design fit and function
- Laid-back front-end, extended A-pillar rails
- Minimally structured greenhouse
- Short rear deck with blended wing stanchions
- Two rear wing options included with side-dams
- 3mm wing mounting hardware with plastic light-weight nuts
- JConcepts A1R decal sheet with window mask
- ROAR approved body
- JConcepts A1R A1 Racer Clear Body (1 pc)
- Rear wing
- Window mask