0 item(s) - USD 0.00

RPM Rear Bumper Mount BLACK for Traxxas 2WD Slash Rustler Stampede Bandit

RPM Rear Bumper Mount BLACK for Traxxas 2WD Slash Rustler Stampede Bandit #80902

Description:

This is a rear bumper mount from RPM, intended for use with the Traxxas Slash, Stampede, Rustler and Bandit 1/10 scale electric vehicles. After hearing numerous requests to look into the rear bumper mount on the Traxxas Slash, RPM has found several issues that could use their special touch. Those same problems were encountered on e-Rustler, e-Stampede & Bandit vehicles using the stock wheelie bar mount. The problem – the stock mount uses only a single screw on the gear cover side to hold the mount in place. That causes a hinge effect under rear impacts causing the slotted area holding on to the rear skid plate to pop off after an impact, leaving the stock bumper/wheelie bar mount hanging under the chassis. The RPM solution…An all-new bumper mounting system that eliminates all of the problems encountered with the stock version.

The RPM rear bumper/wheelie bar mount has two mounting holes on the gear cover side and three on the motor side – that’s two additional mounting points to eliminate that annoying hinge effect mentioned above. The additional mounting screws help disperse impact energy into the transmission case over more surface area, reducing the possibility of damaging the case significantly! The new RPM mount design means no more slotted parts hanging below the rear skid plate – ever! The RPM mount tucks up quite nicely behind the skid plate for better rear end ground clearance.

  • Material: Nylon
  • Color: Black
  • 3x10mm Screw (1pc)
  • 3x12mm Screws (4pcs)
  • 3x16mm Screw (1pc)
  • 3x25mm Screws (3pcs)
  • 3mm Locknut (1pc)
  • RPM sticker (1pc)
  • Instruction
  • ** Please click here for full range of Hop Ups for Traxxas Slash **

    ** Please click here for full range of Hop Ups for Traxxas Rustler Brushed **

    ** Please click here for full range of Hop Ups for Traxxas Rustler Brushless **

    ** Please click here for full range of Hop Ups for Traxxas Stampede Brushed **

    ** Please click here for full range of Hop Ups for Traxxas Stampede Brushless **

    Feature:

  • For: Traxxas Slash, E-Rustler, E-Stampede, and Bandit
  • Include:

  • Mount for a Rear Bumper or Wheelie Bar (1pc)
  • Write a review

    Please login or register to review

    Customers that bought this also purchased...

    RPM 80695
    Front Upper Lower Suspension A arms Blue for Traxxas 1/16 E-Revo
    USD 10.20
    RPM 81002
    Rear Durable Bumper BLACK for Traxxas Slash 2WD
    USD 8.10
    SSD SSD00226
    Diamond 44 Center Housing Set Black For Axial SCX10 II 00226
    USD 9.99
    Sale
    SSD SSD00110
    Rear Axle Shafts for Wide D60 XR Axle 00110
    USD 13.50 USD 15.00