Factory bath is suitable for all types of TT01 . If you decide to replace your bath for some reason, I recommend you DO NOT use stock screws, just spend some money to buy a fine thread screws it will help to forget about the torn thread and extend the life of your new bath . And if you have asphalt track covering the bottom of the bath thick vinyl film, same as used in real car will be perfect.
Exactly the same as the factory tub. I tore out my rear suspension in a crash, this replacement got me back on the road! Includes all factory stickers pre-applied (on/off switch, 7.2v on battery tray, etc.) and all tt-01 cars use this tub (mine was a type E). It's cheap enough to pick one up just in case.
Because the suspension mounts are part of the bathtub chassis, a new chassis will eliminate slop in an older car. Plus, if you've stripped or cracked some screw holes, this will get you back on the road.
It's a shame there isn't a carbon reinforced or carbon fibre chassis available. So this is the best you can get!
This bathhub is made from too weak plastic, on the third screwing the screws will turning out....and you will have to buy a new bathhub or take a bigger screw. Thank you RCMart for the big assortment of parts on my TT-01E!