Buy this item and earn 140 points valued at USD$0.56.
|No problem. Please set the legal frequency.
Over voltage or reverse polarity. Maybe user problem.
Synthesized RF Module
The following frequencies and channel numbers may be used for surface use:
27MHz Band: (car/ boat only)
Next, plug the Synthesized RF module in place of the crystal type module.
Push it all the way in until you hear it "click" to ensure all contacts are in place.
2 On the top of the Synthesized RF module, you will find two rotary dials marked "x10" and "x1".
With the supplied plastic screwdriver,carefully turn the slots in each dial corresponding to the channel number you wish to transmit on.
3 Next, change or select the channel of the receiver to match the channel you have selected.
4Turn on the transmitter first (a signal is transmitted from Synthesized RF module after approx. 1 second)
and then turn on the receiver. To make sure everything is working properly it is advised that you perform a range test
with the transmitter antenna shortest position.
5 If you have confirmed that everything is working properly, then pleased extend the transmitter antenna completely when running or flying your models.
Any changes or modifications not expressly approved by the party responsible for compliance void the user's authority to operate the equipment.
Always use only genuine Futaba receivers.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts.
Use the parts specified in the introduction manual and catalog.
(shared with servos)
CN---27MHz Band: (car/boat only)