Futaba (#6EX-2.4G w/R617FS M1) 6EX 2.4G w/R617FS Receiver/ TX Nicd/ Mode 1
[6EX-2.4G w/R617FS M1]
Our Price: Low Price: USD$189.90
Stock: Out of Stock!
Buy this item and earn 190 points valued at USD$0.76.
|Over voltage or reverse polarity. Maybe user problem.
This is the Futaba 6EX 2.4G With R617FS Receiver
Futaba 6EX 2.4G Transmitter
Model Select – six model memory.
Model Type – select airplane or heli programming in one transmitter.
Servo Reversing – on all six channels.
Dual Rate/Exponential – for ailerons, elevator and rudder.
End Point Adjustment – fine-tunes servo throws on all six channels.
Digital Trim – stores trim settings for each model for aileron, elevator, rudder and throttle.
Fail Safe – a safety throttle setting in case of loss of transmitter signal.
Battery Fail Safe – moves the throttle to a preset position when the airborne pack reaches 3.8V.
Stick Mode – choose from Mode 1 through 4.
Range Checking – Power Down reduces transmitter output power for up to one minute, allowing range checking from 50 paces away.
Changeable Throttle Stick – select ratchet for airplanes or smooth for helis.
Adjustable Stick Length – choose the length that suits your flying style.
High sensitivity receiver weighs only .25oz (7g) without case yet is a full range system for all aircraft from giant scale to park flyer applications-no need to buy separate receiver for specific aircraft
Simple one-touch linking - no plugs to mess with or lose
Dual Antenna Diversity allows 2.4GHz FASST Futaba transmitter to select the best reception between the two receiver antennas with no signal loss
Rubber grommets installed where antennas exit to eliminate stressand fraying of the two antenna wires
Futaba 6EX 2.4G Transmitter
Operating system: 2-stick, 6 channels
Transmitting frequency: 2.4GHZ bands
Power Supply: 9.6V
Current Drain: 170mA
Current drain: 250mA
Airplane-Specific Programming Functions:
Wing Mixing – for flaperon, flap trim, V-tail and elevon.
Trainer System – with the transmitter as either the master or student system. Compatible with other Futaba systems.
Throttle Cut – pre-programmed for safely shutting off the engine.
Programmable Mixing (1 & 2) – two different mixes allow any two channels to be combined.
Helicopter-Specific Programming Functions:
5-Point Normal and Idle Up Throttle/Pitch Curves.
Throttle Hold – for autorotation.
Revo (Revolution Mixing) – mixes rudder and pitch together.
Gyro Mixing – two gyro gain settings can be programmed and selected during flight.
Swash to Throttle Mixing – corrects slowing of the engine's speed caused by the swashplate.
Swashplate Types – choose from 1S (independent aileron, pitch and elevator servos linked to the swashplate), 3S (120° CCPM), or 3E (90° CCPM).
Swash AFR – Adjustable Function Rate, for use with 1S, 3S or 3E swash types.
Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: .35oz (10g) with case
.25oz (7g) without case
6EX 2.4G Transmitter
Futaba NT8F600B 9.6V 600mAh Battery for Transmitter (1pc)
R617FS Receiver (1pc)