*Click the above image to buy it
This new li-po battery (LP-0046) is specifically developed for all 1/10 explosive RC cars. It makes the cars perform speedy! Most of the RC drivers comment it is a MUST buy item especially for the competition! The process of installation is very simple and time-saving which applies to all RC cars. Just strengthen your car with this powerful li-po battery.
For: 1/10 RC Car
Please check the size of the battery can be used with your car
Please confirm your ESC can be supported 11.1V
Discharge rate: 30C
Burst Rate: 50C
Length: Approx. 138mm
Width: Approx. 46mm
Height: Approx. 30.5mm
Weight: Approx. 340g
Why go Li-Po?
Runtime up to 30% longer than traditional NiMH/NiCd (of the same capacity).
Weight up to 40% lighter than traditional NiMH/NiCd (of the same capacity).
Li-Po power delivery ensures maximum power throughout the discharge cycle.
Less internal resistance offered by advanced cell fusion technology.
Less energy lost in form of heat makes a greater power output.
Complicated maintenance-free or conditioning-free.
Balancing port included.
Compatibles 90% of 1/10 scale chassis with little or zero modification.
Can be used and recharged unlimited times per session.
Less cost over time as longer lifespan up to 10 times that of NiMH/NiCd.
Sealed case makes perfect for tracks looking.
For your safety, please read the instruction before use.
Click the icon below to download.PDF
In addition, please make sure that other series of Li-Po Battery Pack within the positive and negative sides or wires are certainly correct before using. You are welcome to inquire us about the subject.
Users should charge the battery within 0.5C rate for the first 8 to 10 sequences.
Subsequently, 1C rate charging is good to maintain the lifespan of battery.
Of course, users may use higher C rate to charge but it will affect the battery performance even life cycle is still short.
Therefore, we recommend all users should follow the above instruction of battery charging.
Want to buy it?
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.