1/10 Crawler Essentials Upgrade COMBO #CB1005
- 1x Holmes Hobbies TorqueMaster Expert 540 Brushed Electric Motor 35t #110100008
- 1x Yeah Racing Tritronic 1/10 Waterproof Brushed 60A ESC #ESC-1060WP
- 2x Gmade XD Piggyback Shock 93mm 2pcs for 1/10 Crawler EP Buggy Short Course Truck #GM21107
- 2x Xtra Speed Aluminum 1.9 Inch 6 Spoke Heavy Duty Beadlock Wheel 2 pcs For 1/10 RC Crawler #XS-59560
- 1x 3Racing Automatic Crawler Winch With Control System #CR01-27
- 1x Yeah Racing Stinger Steel Bumper w/Winch Mount Shackle For Axial SCX10 / SCX10 II#YA-0454
Holmes Hobbies TorqueMaster Expert 540 Brushed Electric Motor 35t #110100008
When you need a quality motor, look no further than the TorqueMaster Expert 540 from Holmes! The Expert series features the same quality construction as our Pro motors, but with a machine wound armature for an affordable alternative that won't break the bank.
- Machine-Wound Armature
- Standup Brush and 10mm commutator
- Gold-plated copper brush hood to resist corrosion and provide lowest resistance
- 5mm web 3 slot armature- Maximizes torque and efficiency
- Can – 1.4mm thick can features minimal venting and two high-power FB9 wet magnets to maximize torque and efficiency
- Dual Ball bearings
- Adjustable timing
- Holmes XX springs for consistent drag brake
- Holmes Soft Copper brushes for high torque and long motor life
- Broken in for immediate installation and use
- TorqueMaster Expert 540 Brushed Motor 35t (1 pc)
Yeah Racing Tritronic 1/10 Waterproof Brushed 60A ESC #ESC-1060WP
After the revolutionary Hacktronic ESC introduction, Yeah Racing is now introducing the almighty Tritronic 1/10 Waterproof Brushed 60A Electronic Speed Controller ESC. It is water-proof & dust-proof, making it almighty to race under all weather condition. It has 3 running modles compatible to various vehicles and multiple protections in case of low voltage, over-heating or Throttle signal loss.
- For: 1/10: Touring Car, Buggy, Short Course Truck, Monster, Truggy, Rock Crawler and Tank
- Water-proof and dust-proof, suitable for all-weather condition races.
- Small size with built-in capacitor module.
- Fwd/Rev/Br running mode fits for various vehicles (Fwd =Forward, Br=Brake, Rev=Reverse).
- Great current endurance capability.
- Great built-in BEC output capacity.
- Automatic throttle range calibration, easy to use.
- Easy to set the ESC parameters with jumpers.
- Multiple protections: Low voltage cut-off protection for battery / Over-heat protection / Throttle signal loss protection.
- Model: ESC-1060WP
- Fwd. Cont. / Peak Current: 60A /360A
- Rev. Cont. / Peak Current: 30A /180A
- Voltage Range: 2-3S Lipo or 5-9 NiMH
- Cars Applicable: 1/10: Touring Car, Buggy, Short Course Truck, Monster, Truggy, Rock Crawler and Tank
- 2S Lipo or 6 NiMH
- 540 or 550 Size Motor: ≥12T Or RPM<30000 @7.2V
- 3S Lipo or 9 NiMH
- 540 or 550 Size Motor: ≥18T Or RPM< 20000 @7.2V
- 4S Lipo or 12 NiMH
- Resistance: Fwd 0.001Ω, Rev 0.002Ω
- BEC Output: 2A/5V (Linear Mode)
- PWM Frequency: 1KHz
- Dimension / Weight: 36.5*32*18 / 39g
- Cooling Fan: Without cooling fan
- Running Modes: Forward/Reverse/Brake, Forward/Brake, Forward/Reverse
- Yeah Racing Tritronic 1/10 Waterproof Brushed 60A ESC (1 Set)
- Manual (1 pc)
Gmade XD Piggyback Shock 93mm for 1/10 Crawler EP Buggy Short Course Truck #GM21107
Really simple to change up setups with piggyback adjustable valve. Driving feeling feels good in onroad & offroad cars.
CNC machined aluminum shock bodies, aeration screws and piggyback bodies
Titanium gray anodized shock bodies
Red anodized aeration screws
Silver anodized piggyback bodies
Lower shock ends includes red anodized aluminum balls
Fully threaded for rapid adjustment
3.5mm thick shock shafts
Shaft exits through double O-ring seals
Easy load shock seal assembly
Laser engraved for authenticity
- For: 1/10 Scale Crawlers, Trucks, EP buggys and Short course Trucks (such as Axial SCX10, Associated B44 and SC10 4x4)
- Material: Aluminum and Titanium
- Color: Black, Gray, Red and Silver
- Length (Mounting hole to hole): 93mm
- Shock Body Diameter: 14mm
- Spring Diameter: 19mm
- Spring Length: 58mm
- Full Shaft Travel Range: 26mm (without Rubber bump stop)
- Shaft Diameter: 3.5mm
- Titanium gray anodized aluminum shock bodies (2 pcs)
- Red anodized aluminum aeration screws (2 pcs)
- Silver anodized aluminum piggyback bodies (2 pcs)
- Shock springs (2 pcs)
- All necessary hardware to finish the shocks
- Assembly instructions (1 set)
- Bottle of shock oil (1 pc)
Xtra Speed Aluminum 1.9 Inch 6 Spoke Heavy Duty Beadlock Wheel 2 pcs For 1/10 RC Crawler #XS-59560
This is Xtra Speed Aluminum 1.9 Inch 6 Spoke Heavy Duty Beadlock Wheel 2 pcs For 1/10 RC Crawler. Xtra Speed has found the perfect blend of design, material, and weight to bring you the best looking, strongest crawler wheels for your crawler.
*Photos for reference only.
- For: 1/10 RC Crawler
- Material: Aluminum
- Color: Black +Silver
- Xtra Speed Aluminum 1.9 Inch 6 Spoke Heavy Duty Beadlock Wheel (2 pcs)
3Racing Automatic Crawler Winch With Control System
This is the 3Racing Automatic Crawler Winch With Control System for Crawler Car.
For: Crawler Car - AXIAL AX10 / Tamiya CR01
Note : 3ch radio kit must have neutral position function
Automatic Crawler Winch (1 Pcs)
Control System (1 Pcs)
Yeah Racing Stinger Steel Bumper w/ Winch Mount and Shackles For Axial SCX10 #YA-0454
This is Yeah Racing Stinger Steel Bumper w/ Winch Mount and Shackles For Axial SCX10 #YA-0454.
This product will fulfill your need for ever more realistic accessories with more scaled accessories.
The Bumper features mounting points for winches and dual tow points with shackles included.
This bumper mounts onto the frame, so it will for sure fit all SCX10 chassis's.
*Photos for reference only.
- For: Axial SCX10 / SCX10 II
- Material: Steel
- Color: Black
- Yeah Racing Stinger Steel Bumper(1 pc)
- Shackles (2 pcs)
- Mounting Hardware (1 pack)